Build Sheet

[bigbirdws6]

thought i would post on here what i am doing to my CETA.

---ENGINE---
ERL LS3 block (superdeck one with 4 bolt per cylinder)
Callies Drangonslayer crank
Oliver Billet rods
Wiseco pistons with top coated
total seal rings
DM performance stud gurdle
Dowel pined Billet main caps. with ARP main studs
AFR 225 heads hand ported by tony M with upgrade valves and springs.
ARP head studs
LS9 head gasket
clevlit bearings (rod, crank, and cam)
rollermaster genIV timing chain
234/228 on a 117lsa cam
LS2 Ported intake( hope to have a willson by turbo time)
92mm TB
yella terra 1.7 rockers
chromoly push rods.(changing to 3/8 pushrods for turbos)
motive lifters(i think that is brand)
ASP dampiner
LT1 radiator
granitelli wires
evans water pump and few little things

---TRANY---
McLeod twin disk
TR6060 (T-56 magnum)
GM slave
Tick Master

---REAREND---
midwest 9" with 35 spline and wavetrac

---SUSPENION---
-front-
BMR custom APS kmember
UMI upper and lower a-arms
strange single adjust coil over
UMI hollow sway bar(not bought yet)
-rear-
DKT LCA
Midwest WATTS
strange coil-over conversion
UMI hollow sway bar(not bought yet)

---Fuel system---
aluminum tank
custom single 255 in tank. and 2 bosch 044 in tank
5/8" feed and return line (-10 AN)
160 or 180 lb injectors

---Turbo System---
APS turbo F-body turbo kit
with upgrade ballbearing turbos @ 65lb min
also going to add scavenger pump

Let me know what you all think.
Thanks
Devin